![]() Bios recovery mode might be also FN+D try both combinations, fans running full speed "might" be indication your entering the mode. I can plug in and HDMI to a monitor and it shows up fine but there is just no display on the laptop screen. I installed the screen powered it on and the screen lit up but there was no display. Keep still holding FN+B ,bios recovery menu (this should recover in some cases). Okay so my screen was cracked and I replaced the screen. You can also try remove power cable, hold FN+B (keep holding) and with other hand plugin power cable then press power on key. This should reset embedded controller.Ĭheck all the USB ports with flashlight to see if any pins look messed up or shorted. ![]() If external gives no picture after that, remove main battery and power connector, then press power button for 30-60 seconds just keep holding it, after that just plug in the power connector without main battery and try to power up. Have you tried to hook up external monitor to the HDMI slot and then power on? There might be key combination required to chnage to external monitor, read from the manual or look for symbols on the keyboard, if you get picture on external its probably that the internal LCD is broken. If it wasnt the GPU what was the problem it might be done now, good thing is these arent that expensive. Put the GPU 10 min on 200 C in the oven.The cooling fans of the computer turn on. I couldnt see anything on the screen except for some vertical bars. I see you tried the "oven" method, idk why this sounds so funny Nothing is showing on the computer display after turning on my computer. A few days later I suddenly got problems while booting my laptop with my screen. Never seen any of these clevo laptops myself but seen from disassemble videos that you can basically swap even gpu in these models which is very nice.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |